Recently, a potential client handed me a nice thick piece of finished hardwood and asked me to see how it looked when laser engraved. The goal is to create a higher quality look than the simple ink stamp he had used for these barrel-shaped plaques previously.
I prepared some engraving tests on the back surface with several power and speed settings to determine how much power the wood needed to get past the stain. As it turned out, no matter how much power I pushed at it, the deep stained grain made the logo and company name illegible. It was a perfect opportunity to try out some color fill paint that Jennifer and I have had for a short while but hadn’t used yet.
I previously used some acrylic paint to fill in an engraved picture frame, but the way the acrylic paint attached itself to the transfer tape made pulling the tape away into a meticulous, time consuming affair. We even needed to touch some areas up after removing the tape because the paint had come with it! Thankfully, this new color fill paint was made specifically to work in tandem with laser engraving. While it’s primarily made to be used to fill engravings on acrylic, my material was a grainy wood. Because I wanted to avoid paint sticking inside that grain, I put down transfer tape before engraving.
I ran two tests, one for a “titanium white” color fill and one with standard black. While the white was immediately and clearly visible, that also meant that some tiny bits of paint that got into the grain underneath the transfer tape were also very noticeable. I could probably prevent that by putting down a clear coat first, but I’d have to make sure to get a clear fill material that wouldn’t adhere to the transfer tape like the acrylic paint used on the aforementioned frame.
The black test is a little harder to read on the already dark wood, but any leaks into the grain were also undetectable and the black filled engraving more closely matched the client’s previous ink stamp design.